Pneumatic Down Force—Air Pressure Sensor

1. 
   A59325-UN-19FEB07

   Menu

   
   A59551-UN-08MAR07

   Planter Button

   
   A59172-UN-29JAN07

   Configuration Softkey

   
   H85801-UN-14JUN06

   Continue

   
   A59369-UN-20FEB07

   Zero Sensor Button

   Select Menu >> Planter button >> Configuration softkey >> Sensor tab.

---




2. Select PDF Air Pressure from drop-down box.

3. NOTE: Step value option is only displayed in the Pneumatic Down Force—Air Pressure Sensor setup screen for Non-XP (Enhanced Monitoring) equipped machines.

   Select Step Value, enter a value for the pneumatic down force system to increase or decrease when adjustment arrows (on run screen) are used for adjustment.

4. NOTE: PDF low alarm option is only displayed in the Pneumatic Down Force—Air Pressure Sensor setup screen for Non-XP (Enhanced Monitoring) equipped machines.

   Select PDF Low Alarm to set the pressure to determine margin. the default setting from the factory is (40 lb.)

5. Select Cal Value input box and enter the calibration value of 494.00.

6. NOTE: Current down force is displayed on bottom left of screen.

   Relieve air pressure before selecting the Zero Sensor button.

Screen Area Information

Planter Configuration - Planter Configuration
Sensor - Sensor
PDF Air Pressure - PDF Air Pressure
Cal Value - Calibration Value
To Zero Air Pressure Sensor: - To Zero Air Pressure Sensor:
Relieve Air Pressure and Press Continue - Relieve Air Pressure and Press Continue