Check and fill reservoir.

Pressurized return line.

Reverse hose connections to tractor or move control lever in opposite direction.

Tractor control valve return line closed.

Cycle tractor control lever in opposite direction momentarily to open.

Tractor flow control set too low.

Increase valve setting.

Tractor pressure too low.

Check and repair tractor hydraulic system. See your John Deere dealer.

Selector valve set for FAN.

Pull valve handle out for AUGER operations.

Drive coupler damaged.

Replace coupling hardware.

Damaged shaft seal.

See your John Deere dealer.

Faulty selector valve.

Repair or replace valve. See your John Deere dealer.

Faulty drive motor.

Repair or replace motor. See your John Deere dealer.

Conveyor belt slips

Tension belt. See procedure in Service section

Secure spout on hook support bracket for proper flow.

Verify that fan/auger selector is set to auger.

Verify that SCV is connected and engaged.

Verify that hydraulic connections are correct.

Verify that remote and receiver are on and paired.

Verify that electrical connectors and properly connected.

Low hydraulic flow.

Verify that SCV is set to correct flow.

Valve contamination.

See your local John Deere Dealer.

Remote not lighting up, or responding.

Verify system operation on other remote.

Verify appropriate battery placement.

Replace batteries.

Follow remote pairing procedure.

LD45720,0000525-19-20140625