Quick-Coupling (Hook-Type) Draft Links

These draft links are intended for Category II and Category IIIN implements. Implements can be attached to and removed from the draft links without the driver having to leave his seat.

To open the links, simply pull the cable.

To close the links, simply release the cable.

NOTE: On very heavy, compact implements, the lift links can be attached at the rear hole in the draft links. This reduces the lifting height, but maximizes the lifting force.

 

LX1019437
LX1019438

OU12401,000058C -19-01MAY01-1/3

Attaching Implement

1. Adjust draft links to the dimension for Category II implements by means of adjusting rod (A) (if equipped on 6520 and 6620 tractors).

2. With draft links lowered, reverse tractor until the coupler hooks are below the implement hitch pins.

3. Slowly raise draft links until pins are engaged in coupler hooks and locked into position.

4. Adjust center link to required length and attach to top attaching point of implement mast.

IMPORTANT: Make absolutely certain that implement is correctly locked to coupler hooks.

LX012514

OU12401,000058C -19-01MAY01-2/3

Removing Implement

1. Lower implement to the ground.

2. Disconnect center link from implement and secure by means of transport hook.

3. Pull release cable (A) and lower draft links until coupler hooks are clear of implement hitch pins.

4. Drive tractor forward away from implement.

LX1026077

OU12401,000058C -19-01MAY01-3/3