Indicator Lights (Tractors without Cab)

LX1026192

1-The red "STOP" light flashes when a serious malfunction occurs (indicator lights 8, 9 or 10 come on). Switch off the engine IMMEDIATELY and determine the cause.

2-The yellow "CAUTION" light flashes when indicator lights 8, 12, 13 or 14 come on, and when the handbrake is applied with the engine running and a gear engaged or the reverse drive lever set to any position other than neutral.

3-This light flashes when there is a fault in an electrical component associated with the hydraulic system or transmission. See your John Deere dealer.

4-This light comes on when the differential lock is engaged.

5-This light comes on when front-wheel drive is selected.

6-The handbrake indicator light glows when handbrake is applied and engine is running. In addition, an acoustic warning signal may be installed.

7-This light comes on when the rear PTO is selected.

8-This warning light glows when transmission/hydraulic oil temperature is too high.

9-If this warning light glows, transmission/hydraulic oil pressure is too low. See your John Deere dealer.

10-If engine oil pressure warning light glows with engine running, shut off engine and check the level of engine oil.

11-The full-beam indicator light will glow whenever the headlights are switched on at full beam.

12-If alternator indicator light glows with engine running, this indicates a defect at alternator. Check alternator cables. If necessary, have alternator checked by your John Deere dealer.

13-If air cleaner indicator light glows with engine running, the air cleaner element must be cleaned or replaced.

14-This light glows when the transmission oil filter is clogged or the oil temperature is too low.

15-This light comes on when the worklights are selected.

16-The flashing indicator light for tractor starts flashing when turn-signal or hazard warning lights are switched on.

17-The flashing indicator lights for trailer start flashing when turn-signal or hazard warning lights are switched on.

OU12401,00009C2 -19-01JAN02-1/2


Bulb test: As the engine is started, all the lights should glow for approx. 1 second. If this is not the case, a defective bulb or blown fuse may be the cause. Check and replace parts as necessary.

The indicator lights should go out as soon as the engine is running.

OU12401,00009C2 -19-01JAN02-2/2