Changing Oil in Final Drives (Front-Wheel Drive Axle with Brake)

Replace oil in the final drives after the first 100 hours of operation. Then replace after every 750 hours of operation. Always use a transmission oil listed in the "Fuel, Lubricants, Hydraulic Oil and Coolant" section.

causym CAUTION: If final drives are hot, oil is under pressure. Remove drain screw slowly.

1. Turn wheel until drain screw (A) is at the bottom. Remove drain screw and drain oil into a suitable container.

2. Turn the wheel through 90° so that the line marked "Ölstand" is horizontal (see "Service / Every 250 Hours") and fill with fresh oil at drain screw bore. Oil should be level with plug bore.

3. Re-install the drain plug and tighten to 150 N·m (110 lb-ft) on 6520 to 6820 tractors and to 120 N·m (90 lb-ft) on 6920 and 6920S tractors.

Tractors
 Oil capacity
6520 to 6820...
6920 and 6920S...		 1.00 Liter (0.3 U.S.gal.)
2.50 Liter (0.7 U.S.gal.)

 
LX1019743
LX1029258

OU12401,0000B16 -19-01JUL02-1/1