1-The red "STOP" light flashes when a serious malfunction occurs (indicator lights 7, 8 or 9 come on). Switch off the engine IMMEDIATELY and determine the cause.

2-The yellow "CAUTION" light flashes when indicator lights 11, 12 or 13 come on, and when the handbrake is applied with the engine running and a gear engaged or the reverse drive lever set to any position other than neutral.

3-This light comes on when the differential lock is engaged.

4-This light comes on when front-wheel drive is selected.

5-The handbrake indicator light glows when handbrake is applied and engine is running. In addition, an acoustic warning signal may be installed.

6-This light comes on when the rear PTO is selected.

7-This warning light glows when transmission/hydraulic oil temperature is too high.

8-If this warning light glows, transmission/hydraulic oil pressure is too low. See your John Deere dealer immediately.

9-If engine oil pressure warning light glows with engine running, shut off engine and check the level of engine oil.

10-The full beam indicator light will glow whenever the headlights are switched on at full beam.

11-If alternator indicator light glows with engine running, this indicates a defect at alternator. Check alternator cables. If necessary, have the alternator checked by your John Deere dealer.

12-If air cleaner indicator light glows with engine running, the air cleaner element must be cleaned or replaced.

13-This light glows when the transmission oil filter is clogged or the oil temperature is too low.

14-This light comes on when the work lights are selected.

15-The flashing indicator light for tractor starts flashing when turn-signal or hazard warning lights are switched on.

16-The flashing indicator lights for trailer start flashing when turn-signal or hazard warning lights are switched on.

17-When the engine starts, this light comes on to indicate that the PTO is already engaged.

OU12401,0001106 -19-04OCT04-1/2

NOTE: If the PTO is already engaged when the engine is started, the PTO will not operate. The PTO must be disengaged and then re-engaged before it will start to turn.

Indicator lights 1, 2 and 11 should light up briefly every time the engine is started. They should go out as soon as the engine is running.

OU12401,0001106 -19-04OCT04-2/2