Attaching PTO-Driven Equipment
 CAUTION:
Shut off engine and disengage PTO before attaching PTO-driven equipment.
CAUTION:
High-inertia implements do not come to a standstill the moment the PTO control lever is shifted to the disengaged position. Allow sufficient time for implements to "coast down" to a halt after disengaging the PTO.
CAUTION:
Before attempting to clean, adjust or lubricate a PTO-driven machine, the three-point hitch or the universal jointed shaft, always make sure the PTO is switched off, the tractor engine is shut off and the ignition key is removed.
1.
Align swinging drawbar (A) parallel to PTO shaft and lock it in position.
2.
If necessary, install hammer strap
1
as shown in the picture. Tighten nut (C) to 520 N·m (280 lb-ft) and nut (D) to 375 N·m (275 lb-ft).
3.
Distance (B) from end of PTO shaft to hole in drawbar end should be 350 mm (13.8 in.) for the 540 rpm PTO and 400 mm (15.7 in.) for the 1000 rpm PTO.
|
