High Clearance Drawbar

IMPORTANT: Use high clearance drawbar with stabilizer chains (B) only.

Adjust stabilizer chains (B) until it is impossible for the draft links in lowered position to move under PTO housing.

The drawbar can be adjusted to three positions (see arrows).

Before swinging the drawbar:

1. Remove locking pin (D) and pin (C).

2. Pull out drawbar and rotate locking device (A) to the rear (see arrow).

3. Push in drawbar and insert pin (C).

4. Secure pin (C) with locking pin (D).

The drawbar can be adjusted lengthwise to two positions:

350 mm (13.8 in.) and 400 mm (15.7 in.)

The lengths determine the distance from the end of the PTO shaft to the attaching point of the drawbar.

LX008323

LX,OZUS006336 -19-01APR98-1/1