Changing Transmission/Hydraulic Oil (Tractors NOT Equipped with IVT)1. Start engine and operate hydraulic functions to heat up oil.2. With tractor on level ground, shut off engine and remove key from ignition. 3. Shift transmission to "PARK". 4. Lower draft links. 5. Remove drain screws (A). 6. Replace transmission/hydraulic oil filter elements (B). 7. Remove plug (C), pull out intake screen and wash in fuel. 8. Before refilling with fresh oil, reinstall intake screen and tighten drain screws to 50 N·m (35 lb-ft). 9. Refill transmission housing with transmission/hydraulic oil. 10. Run engine briefly and operate hydraulic functions. Shut off engine and wait five minutes. 11. Lower the draft links. 12. Check oil level. It should be level with upper mark on dipstick. If not, correct oil level. |
|
| Capacities: | |
|---|---|
| SYNCROPLUS™ transmission with 12/4 gears...52 liters (13.7 U.S.gal.) | |
| SYNCROPLUS transmission with Power Reverser with 16/16 gears...52 liters (13.7 U.S.gal.) | |
| POWRQUAD™ and POWRQUAD PLUS transmission with 16/16 gears...49 liters (12.9 U.S.gal.) | |
| POWRQUAD™ PLUS and AUTOQUAD II transmission with 24/24...50 liters (13.2 U.S.gal.) | |
| Extra for creeper transmission...1 liter (0.3 US.gal.) | |
| Extra for front-wheel drive...3 liters (0.8 US.gal.) | |
| Extra for TLS-axle...3 liters (0.8 US.gal.) |
|
SYNCROPLUS is a trademark of Deere & Company. | OU12401,0000BD2 -19-01JAN03-1/1 |