Replacing the Drive Belt

Pull catch and turn the hood upward.

OU12401,0010291 -19-21MAY01-1/5

CAUTION: Disconnect the battery ground cable (-).

Slacken off the four hex. nuts and push the fan forward.

Use a 15 mm (19/32 in.) wrench to turn the cap screw in the idler roll clockwise (see arrow) until the two holes (A) and (B) are aligned.

Insert a metal pin with a dia. of 5 mm (0.2 in.) into the two aligned holes.

Before tensioning, turn the idle roll a little to relieve the pressure on the metal pin, and then take out the metal pin. The drive belt tensioner returns to its tensioning position automatically.

A-Hole (cam)
B-Hole (base plate)
C-Idler roll

OU12401,0010291 -19-21MAY01-2/5

Remove old drive belt from pulleys, and cut.

Remove the three expanding plugs (A) of the shroud. Place a loop of the new drive belt (B) between fan and shroud.

OU12401,0010291 -19-21MAY01-3/5

Turn fan while at the same time placing the drive belt around the fan.

OU12401,0010291 -19-21MAY01-4/5

Slacken drive belt tensioner and install drive belt correctly.

For further assembly, see "Removing Drive Belt".

A-Crankshaft
B-Idler roll
C-Fan
D-Alternator
E-Deflection roll
F-Compressor (air conditioning system)
G-Coolant pump

OU12401,0010291 -19-21MAY01-5/5