Adjusting Spreading Dimension
Drive tractor to the center of the implement. Remove ring (B) and lift up flap cover (A). Use lever (H) to adjust the spreading dimension.
Groove (G) indicates the spreading dimension for Category II and must be aligned with the edge (see arrow). Then locate lever (H) on pin (C), put down flap cover (A) and secure with ring (B). Finally, adjust spacer (D).
IMPORTANT:
The spreading dimension must be large enough to prevent draft links (E) from interfering with sway blocks (F), as this may result in mechanical damage.
A-Flap cover
B-Ring
C-Pin
D-Spacer
E-Draft link
F-Sway block
G-Groove for Category II
H-Lever
|
