Changing Oil in Final Drives (Front-Wheel Drive Axle with Brake)Replace oil in the final drives after the first 100 hours of operation. Then replace after every 750 hours of operation. Always use a transmission oil listed in the "Fuel, Lubricants, Hydraulic Oil and Coolant" section.
1. Turn wheel until drain screw (A) is at the bottom. Remove drain screw and drain oil into a suitable container. 2. Turn the wheel through 90° so that the "Ölstand" mark is at the bottom (see "Service - Every 250 Hours"), and add oil at the hole for the screw plug. Oil should be level with plug bore. 3. Re-install drain screw and tighten to 150 N·m (110 lb-ft). Capacity: 1.5 liters (0.4 U.S.gal.). |
|
CAUTION:
If final drives are hot, oil is under pressure. Remove drain screw slowly.
AG,OU12401,252 -19-08APR00-1/1 |