|
The front axle can be adjusted at each end in increments of 51 mm (2 in.). Maximum wheel tread is obtained by reversing the front wheels.
If front wheels are removed to adjust tread, tighten front wheel bolts to 250 N·m (185 lb-ft) once the wheels are replaced.
IMPORTANT:
After the first 4 and 8 hours of operation, retighten all front wheel bolts. Check tightness of these bolts frequently during the next 100 hours of operation.
NOTE:
Wheel tread on tractors equipped with a front loader must not exceed 1.80 m (71 in.).
IMPORTANT:
To avoid excessive stress on axle bolts, do not separate axle halves beyond the specified limits.
|
NOTE:
On tractors with axle extension, tread width increases by up to 542 mm (21.3 in.).
| Tires |
Wheel disk inward |
Wheel disk outward |
7.50-18
7.50-20
10.00-16
11L-15
11L-16
|
1491 - 2001 mm
58.7 - 78.8 in.
1487 - 1997 mm
58.5 - 78.6 in.
1493 - 2003 mm
58.8 - 78.9 in.
-
|
1531 - 2041 mm
60.3 - 80.4 in.
1533 - 2043 mm
60.4 - 80.4 in.
1533 - 2043 mm
60.4 - 80.4 in.
1538 - 2048 mm
60.4 - 80.6 in. |
|