Wheel Slip (3)

Radar must be operational to provide true ground speed. If true ground speed is not available, "---" will be displayed.

Press %SLIP switch (A). Bargraph and numeric display will show current wheel slip.

Press switch again to display the wheel slip alarm setting. An alarm symbol will be displayed.

NOTE: Illustration shows current wheel slip (B) is 10%, with an alarm setting at 12% (C). The alarm symbol (D) indicates this alarm set mode.

Bargraph flashes when wheel slip exceeds alarm limit. Each bar on the bargraph represents 2% wheel slip.

Press (E), to change alarm value.

Input alarm setting using touch pad, then press (E).

NOTE: Entering "0" as an alarm value will shut off alarm.

A-% Slip Switch
B-Bargraph
C-Numeric Display
D-Wheel Slip Alarm
E-Set/Save Switch

LX005372 -19-01OCT93-1/1