Press switch again to display wheel speed (A).

Press switch again to toggle between these modes.

NOTE: True ground speed may be different than wheel speed. If tractor is not equipped with radar, only wheel speed will be displayed.

Radar Calibration (after new rear tires have been installed):

Mark a 122 meter (400 ft) straight-line course (start and finish lines).

Rear PTO must be switched off

Press DISTANCE switch (D) and SPEED switch (E) four seconds. Display field will show "---" and the "ft" and "m" symbols will flash. The "implement" arrow should be pointing up.

NOTE: SPEED and DISTANCE switches must be pressed at the same time for correct calibration.

Drive the tractor at a speed of approximately 3.2 km/h (2 mph). As the tractor crosses the start-line, press the IMPLEMENT switch (C), to point the indicator arrow to the down position.

Press the IMPLEMENT switch (C) as you cross the finish-line to change the arrow to the up position.

Display will alternate between "122 m and 400 ft" when calibration is successful.

NOTE: "Err" will flash on display if calibration was not performed correctly. Previous calibration value will stay in memory.

Press "SPEED" switch to display vehicle speed or another display.