Checking Oil Level in MFWD Final Drives

1. Turn wheel until "OIL LEVEL" mark (A) is in level position.

2. Remove level plug (B). Oil should be level with plug bore.

3. If necessary, top up axle at this point. Tighten level plug to 150 N·m (110 lb-ft.). Always use a transmission oil listed in the "Fuel, Lubricants, Hydraulic Oil and Coolant" section.

NOTE: Replace oil in axle housing and final drives after the first 100 hours of operation. Then replace after every 1500 hours of operation or once every 2 years, whichever occurs first.

LX000519

LX,OACH000412 -19-01SEP92-1/1