Changing Transmission/Hydraulic Oil (Tractors with AutoPowr)

1. Start engine and operate several hydraulic functions to heat up oil.

2. Park tractor so that it is level. Lower draft links and front-mounted implements.

3. Turn off engine and remove key.

4. Apply handbrake (transmission in "P").

5. Remove drain screws (A).

6. Replace transmission/hydraulic oil filter element (B).

7. Add transmission/hydraulic oil to the transmission case.

Run engine briefly and operate hydraulic functions. Shut off the engine.

Tighten bleed valve (C) by at least 2 turns. Wait for between 10 and 15 minutes before checking the oil level. It should be between the marks on the dipstick. If not, correct oil level. Remember to close the bleed valve tightly.

A-Drain screws
B-Transmission/hydraulic oil filter
C-Bleed valve
D-Additional oil reservoir

OU12401,00005AA -19-01FEB01-1/1