Changing Transmission/Hydraulic Oil (Tractors NOT Equipped with AutoPowr)

1. Start engine and operate several hydraulic functions to heat up oil.

2. Park tractor so that it is level. Lower draft links and front-mounted implements.

3. Turn off engine and remove key.

4. Apply handbrake (transmission in neutral).

5. Remove drain screws (A).

6. Replace transmission/hydraulic oil filter elements (B).

7. Remove screw plug (C), pull out intake screen and wash in fuel.

8. Before refilling with fresh oil, reinstall intake screen, replace seals and tighten drain screws to 50 N·m (35 lb-ft).

9. Add transmission/hydraulic oil to the transmission case.

LX009834
LX009447


A-Drain screws
B-Transmission/hydraulic oil filters
C-Screw plug
D-Additional oil reservoir

Capacities:
SyncroPlus transmission with 12/4 gears... 52 liters (13.7 U.S.gal.)
Power Reverser with 16/16 gears... 52 liters (13.7 U.S.gal.)
PowrQuad transmission with 16/16 or 16/12 gears... 49 liters (12.9 U.S.gal.)
PowrQuad transmission with 20/20 gears, or 24/24 or 24/16 gears... 50 liters (13.2 U.S.gal.)
AutoQuad II transmission with 16/16 or 16/12 gears... 49 liters (12.9 U.S.gal.)
AutoQuad II transmission with 20/20 gears, or 24/24 or 24/16 gears... 50 liters (13.2 U.S.gal.)
Extra for creeper transmission...  1 liter (0.3 U.S.gal.)
Extra for front-wheel drive...  3 liters (0.8 U.S.gal.)
Extra for TLS axle...  3 liters (0.8 U.S.gal.)
Extra for additional oil reservoir... 10 liters (2.6 U.S.gal.)

 

Run engine briefly and operate hydraulic functions. Shut off engine and wait 5 minutes.

Check oil level. It should be between the marks on the dipstick. If not, correct oil level.

OU12401,00005AB -19-01FEB01-1/1