Changing Oil In Final Drives (Front-Wheel Drive Axle)

CAUTION: On axles with brakes: If final drives are hot, oil is under pressure. Remove drain screws slowly.

1. Turn wheel until drain screw (A) is at the bottom. Remove drain screw and drain oil into a suitable container.

2. Turn the wheel through 90° so that the "Ölstand" mark is at the bottom (see "Service - Every 250 Hours"), and add oil at the hole for the screw plug. Oil should be level with plug bore.

3. Re-install the drain plug and tighten to 150 N·m (110 lb-ft) on 6510 to 6810 tractors and to 120 N·m (90 lb-ft) on 6910 and 6910S tractors.

For capacities, see "Specifications".

LX,OMWAR013359 -19-01MAY00-1/1