Changing Transmission/Hydraulic Oil (Tractors with AutoPowr)1. Start engine and operate several hydraulic functions to heat up oil.2. Park tractor so that it is level. Lower draft links, front loader, front implements and other implements that draw oil from the transmission. 3. Shut off engine and remove the key. 4. Apply handbrake (transmission in "P"). 5. Remove drain screws (A). 6. Replace transmission/hydraulic oil filter elements (B). 7. Take out screw-plug (C). Pull out intake screen and wash it in fuel. Clean the area where the intake screen is installed. Re-install the intake screen. 8. Before refilling with fresh oil, replace seals and tighten drain screws to 50 N·m (35 lb-ft). 9. Add transmission/hydraulic oil to the transmission case. For capacities, see "Specifications". Run engine briefly and operate hydraulic functions. Shut off engine. Wait for between 10 and 15 minutes before checking the oil level. It should be between the marks on the sight-glass. If not, correct oil level. |
|
OU12401,000171E -19-02APR07-1/1 |