Convertible Quick Coupler (If Equipped)

NOTE: Tractor may be equipped with a Category 3N/2 quick coupler. Use category 3N whenever possible. Use following procedure to convert quick coupler from category 3N to category 2 or vice versa.

1. 
   RXA0091514-UN-14NOV06

   A - Crossbar

   B - Pin Cap Screw (1 per side)

   C - Pin (1 per side)

   D - Side Member

   E - Side Member Cap Screw (4 per side)

   Install support stands under crossbar (A).

---




2. Remove cap screw (B) and pin (C) from side member (D) and draft link on one side of tractor.

3. Remove four cap screws (E) from side member (D) and crossbar (A).

4. Move side member (D) up or down to convert quick coupler.

5. Reinstall four cap screws (E) in lower four holes for category 2 or upper four holes for category 3N.

6. Tighten cap screws (E) to specification.

   Item	Measurement	Specification
   Quick Coupler Cap Screw	Torque	240 N•m (177 ft-lb)

7. Reinstall quick coupler to draft link with pin (C) and cap screw (B).

8. Repeat all steps for opposite side.