Change Transmission/Hydraulic Oil (Tractors NOT Equipped with IVT)

Tractors 7130 and 7230 (without IVT)

1. 
   LX1036561-UN-30MAY05

   Transmission/Hydraulic Oil Filters and Drain Screws (7130 and 7230 without IVT)

   Start engine and operate several hydraulic functions to heat up oil.

---




2. Park tractor so that it is level. Lower draft links, front loader, front implements and other implements that draw oil from the transmission.

3. Stop the engine and remove the key.

4. Engage the park lock.

5. Remove drain screws (A) and trap oil in a suitable container.

6. Replace transmission/hydraulic oil filter elements (B). See Service / Every 750 Hours.

7. 
   LX1042828-UN-26FEB07

   
   LX1042829-UN-26FEB07

   Intake Screen (7130 and 7230)

   A - Drain Plug (50 Nm; 37 lb.-ft.)

   B - Screw-Plug (50 Nm; 37 lb.-ft.)

   C - Intake Screen

   Remove screw-plug (B), pull out intake screen and wash in fuel. Clean the area where the intake screen is installed. Re-install the intake screen.

---




8. Before refilling with fresh oil, replace seals and tighten drain screws to 50 Nm (37 lb.-ft.).

9. Add transmission/hydraulic oil to the transmission case. For capacities, see Specifications.

Run engine briefly and operate hydraulic functions. Shut off the engine.

Wait for between 10 and 15 minutes before checking the oil level. It must be between the marks on the sight-glass. If not, correct oil level.

Tractors 7330 to 7530 (without IVT)

LX006244-UN-07AUG95

Transmission/Hydraulic Oil Filter and Drain Screws (7330 to 7530 without IVT)

A - Drain Screws

B - Transmission/Hydraulic Oil Filters

C - Plug

1. Start engine and operate several hydraulic functions to heat up oil.

2. Park tractor so that it is level. Lower draft links, front loader, front implements and other implements that draw oil from the transmission.

3. Stop the engine and remove the key.

4. Engage the park lock.

5. Remove drain screws (A) and trap oil in a suitable container.

6. Replace transmission/hydraulic oil filter elements. See Service / Every 750 Hours.

7. 
   LX1049818-UN-08OCT10

   Tractors (7330 to 7530 without IVT)

   A - 2 Screws (37 Nm; 27 lb.-ft.)

   B - Intake Screen

   C - Intake Screen

   D - Intake Line

   E - 3 Screws (18 Nm; 13 lb.-ft.)

   Remove intake line (D) and take out screws (A). Remove intake screens (B) and (C) and wash them in fuel. Clean the area where the intake screens are installed.

---




8. Re-install all parts as shown and tighten screws to specified torque.

9. Before refilling with fresh oil, replace seals and tighten drain screws to 50 Nm (37 lb.-ft.).

10. Add transmission/hydraulic oil to the transmission case. For capacities, see Specifications.

Run engine briefly and operate hydraulic functions. Shut off the engine.

Wait for between 10 and 15 minutes before checking the oil level. It must be between the marks on the sight-glass. If not, correct oil level.