OMAL200158

Symptom	Problem	Solution
Hydraulic system fails to function	Not enough oil in the system	Top up to mark on dipstick.
	Plugged hydraulic filters	Replace filter.
	Dirt in hydraulic pump	Check filters for clogging.

Hydraulic oil overheats	Oil cooler air passages clogged	Clean oil cooler.
	Dirt in hydraulic pump	Check filters for clogging.

Hitch fails to lift load

Excessive load on hitch

Adjust auxiliary springs on implement or reduce load.

Hitch rate-of-drop too slow

Rate-of-drop regulator not adjusted properly

Adjust rate-of-drop.

Insufficient sensitivity to load control

System regulator in Height or Load-and-Depth Control position

Place system regulator in Load Control position.

Hitch too active

System regulator in Load Control position

Place system regulator in Load-and-Depth position.

Direction of remote cylinder travel is reversed

Hoses not connected properly

Connect hoses correctly.

Remote cylinder will not lift load	Excessive load	Adjust auxiliary springs on implement or reduce load.
	Hoses on quick-coupler not correctly attached	Connect hoses properly.
	Air in remote cylinder	Bleed air from cylinder.

Remote cylinder travels too fast or too slowly

Rate-of-lift is adjusted incorrectly

Adjust rate of lift.

OU12401,0001A75-19-20080826