Installing the Monitor

Attaching the performance monitor and controls

    There are several possible locations for attaching monitors and controls in the cab:

  • On the front right post.
  • On the center posts. 1
  • On the rear posts.

NOTE: Gap between holes at attaching points is 120 mm (4.72 in.) - M10 thread

Take off the relevant trim and turn it over. The positions where holes may be drilled are already marked on the inside.

LX1047146
LX1036240
LX1036241
LX1036242

1If equipped

OU12401,0001A9F -19-12SEP08-1/1