-
Lights - check that all lights (including headlights) are functioning
properly.
-
Fuel system - drain water and sediment from fuel filter.
-
Engine - remove contaminant from area surrounding the engine.
-
Cooling system/air conditioning system - clean the radiator
and condenser, fins and screens.
-
Check brakes.
-
Oil level - check the transmission/hydraulic system.
-
Check the level of oil in the engine.
-
Cooling system - check coolant level.
-
Three-point hitch - lubricate lift links and rockshaft.
-
Front axle - lubricate knuckle pin bearing.
-
Front-wheel drive axle - lubricate all universal joints including
u.j. shaft from transmission to front-wheel drive axle.
-
Front-wheel drive axle with TLS - lubricate Panhard link and
hydraulic cylinder.
-
Access the service codes, rectify fault and then delete the
codes.
-
Check neutral start circuit.
-
PTO actuation - check safety device.
-
Lights - check settings of headlights.
-
Load center - visually inspect and clean.
-
Fuel system - drain water and sediment from fuel tank.
-
Front axle without front-wheel drive - tighten screws.
-
Wheels - front and rear wheels, check torques of attaching bolts.
-
Wheels - wheel dish to rim, check torques of attaching screws.
|
-
Wheels - wheel weights, check torques of attaching screws.
-
Wheels - dual wheel attachment, check torques of attaching screws
(see manufacturer's specifications).
-
Cab - cab mountings, check torque of attaching screws.
-
Cab - ground strap, check torque of attaching screws.
-
Drawbar - check torques of attaching screws.
-
Front loader - attaching frame, check torques of attaching screws.
-
Front hitch - attaching frame, check torques of attaching screws.
-
Check oil level - front-wheel drive axle, axle housing.
-
Check oil level - front-wheel drive axle, final drives.
-
Check oil level - front PTO.
-
Air intake hoses, check for leaks.
-
Foot brakes, operational check.
-
Park lock, operational check.
-
Drawbar - check all components for wear; check that all components
function properly.
-
Front axle without front-wheel drive - lubricate the grease
fittings.
-
Lubricate pivoting fenders, and perform operational check.
-
Rear PTO, lubricate PTO stub shaft support (with pivotable PTO
stub shaft).
|
