Tighten Rear Wheel Bolts (with Rack-and-Pinion Axles) - (6105M to 6125M only)
Tread adjustment instructions
LX1056779-UN-06FEB13
Pinion Hub-Half
LX1056780-UN-06FEB13
Cast Wheel
LX1056779-UN-06FEB13
Pinion Hub-Half
LX1056781-UN-06FEB13
Steel Wheel
|
Cast Wheel |
Steel Wheel |
||
|---|---|---|---|
|
A |
Pinion hub-half to wheel dish Attaching screws 220 Nm (160 lb.-ft.) |
A |
Pinion hub-half to wheel dish Attaching screws 220 Nm (160 lb.-ft.) |
|
B |
Wheel hub to hub half Attaching screws 400 Nm (300 lb.-ft.) |
B |
Wheel hub to hub half Attaching screws 400 Nm (300 lb.-ft.) |
|
C |
Rim to cast dish Attaching screws 220 Nm (160 lb.-ft.) |
C |
Rim to steel dish Attaching screws 220 Nm (160 lb.-ft.) |
|
— |
— |
D |
Steel dish to wheel hub Attaching screws 400 Nm (300 lb.-ft.) |
CAUTION: Avoid injury. Never operate tractor with loose wheel
bolts. Wheel bolts are critical and require retightening.
IMPORTANT: Retighten the bolts to the prescribed torque after operating 3 HOURS and 10 HOURS.
IMPORTANT: The distance between the side wall of the tire and the fender must not be less than 40 mm (1.57 in.)1.
The distance between the running surface (edge) of the tire and the fender must not be less than 60 mm (2.36 in.)1.
If snow chains are installed on the tires, the minimum distance from the tires to the fenders (side wall to fender and running surface to fender) must be 100 mm (3.94 in.).
IMPORTANT: Do not use clamp-on style duals when the tractor is equipped with steel wheels and flanged axle.
|
1 Europe only. In non-European countries, a minimum
clearance of 25 mm (1.0 in.) is recommended.
|
OULXA64,0002D96-19-20140408 |