TIA™ - Requirements for Rear Hitch

Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the operator's manual of the implement.

While operating, implement has ability to control hitch depth.

NOTE: Operator sets raise limit using tractor CommandCenter™. This limit cannot be exceeded by implement.

The following preconditions have to be met before transferring implement control:

• Operator sitting in seat.
• Hitch must be functional.
• Hitch is not locked.
• Do not touch any hitch control buttons.

Transfer control using AutoTrac™ resume switch (see implement Operator's Manual).

To withdraw control:

• Press hitch control button.
• Lock hitch (transport lock.)
• Actuate fender switch (if equipped).

NOTE: Unless implement is authorized to adjust hitch depth when tractor is stationary, tractor will prevent hitch control when stationary.