TIA™ - Requirements for Electronic Selective Control Valves

Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the operator's manual of the implement.

While operating, implement has ability to:

• Control SCVs during operations.
• Change SCV flow rate up to limit set by operator.
• Move the SCVs to all of their 4 positions (retract, extend, neutral and float).

NOTE: Using tractor's CommandCenter, operator sets SCV flow limit which cannot be exceeded by implement.

The following preconditions have to be met before transferring implement control:

• Operator sitting in seat.
• SCVs are without malfunctions.
• SCV control levers in neutral position.
• The selective control valves are not locked (lock button for SCVs).

Transfer control using AutoTrac™ resume switch (see implement Operator's Manual).

To withdraw control:

• Actuate corresponding SCV control lever.
• Selective control valve locked (lock button for SCVs).
• Actuate SCV fender remote control switch (if equipped).

NOTE: Unless implement is authorized to adjust SCV flow when tractor is stationary, tractor will prevent SCV flow adjustments when stationary. Implement is allowed to stop oil flow.