Front-Wheel Drive Axle - Final Drives without Brakes, Check Oil Level

LX1057419-UN-01JUL14

CAUTION: The oil may be under pressure when it is hot. Unscrew the level screw plug slowly.

1. Turn the wheel until OIL LEVEL mark (B) is horizontal.

2. Remove oil level screw plug (A) and put a new O-ring on it. Oil must be level with drain screw bore.

3. If necessary, top up with oil at this point. Put a new O-ring on the level plug and tighten it to 90 Nm (66 lb.-ft.).

Oil to be used

Hy-Gard™ Transmission/Hydraulic Oil. See also Section 80 (Fuel, Lubricants, Hydraulic Oil and Coolant).

NOTE: Replace oil in the final drives after the first 100 and after the first 1500 hours of operation. Then change after every 1500 hours of operation or once every 2 years, whichever occurs first.