OMAL219592

Symptom	Problem	Solution
Hydraulic system fails to function	Not enough oil in the system	Correct the oil level.
	Open electrical circuit	Check fuses.

Filter plugged/by-passed warning is active

Plugged filter

Replace filter.

Hydraulic oil overheats	Cooling system overloaded	Dirty oil cooler. Coolant level low.
	Selective control valve accidentally locked in operating position	Move selective control valve to neutral position.

Hitch fails to follow lever or knob position

Fault in sensor circuit for the lever position or the hitch

Contact your authorized dealer.

Hitch fails to lift under load

Excessive load on hitch

Reduce load.

Hitch lifts slowly

Raise rate too slow

Adjust raise rate, see section 50

Hitch rate-of-drop too slow

Rate-of-drop not adjusted properly

Adjust rate-of-drop.

Insufficient sensitivity to load control

System regulator in depth control or mixed control position

Move system regulator to load control position.

Excessive sensitivity when attaching implements

System regulator in load control position

Place system regulator in depth control position.

Selective control valves not functioning

Hoses not connected properly

Correct hose connections.

Hydraulic cylinder operates too fast or too slow

Rate of flow adjusted wrong.

With mechanical SCVs, adjust the flow control valve.

OULXA64,0003B80-19-20160125