Air Comfort Seat - MSG95G and MSG95GL

LX1053713-UN-27JUL11

LX1053462-UN-27JUN12

CAUTION: Danger of injury resulting from confined spaces!

The following can represent a crush hazard when the seat is being adjusted:

• Objects placed in the cab.
• Additional equipment in the cab.
• Little clearance to adjacent components.

Only adjust the seat when the tractor is standing still.

Set the seat to a position where no accidental contact occurs with the control elements and other components.

As a rule, when driving the tractor, align and latch the operator's seat in direction of travel.

• A — Fore/aft adjustment

  Pull lever (A) up and move the seat to the desired position. Let the lever click into place.

• B — Indicator scale of the weight and height adjustment

  The green mark on the scale indicates whether the weight or height setting is correct.

• C — Adjust fore/aft suspension
  • Lever (C) forward - no fore/aft suspension
  • Lever (C) backward - fore/aft suspension active

• D — Weight adjustment

  There must be weight on the seat for it to be adjusted to suit the weight of the operator. To adjust the seat to the operator's weight, start the engine, allow the seat to settle, then pull lever (D) up or push it down until the green mark appears on the indicator scale (B).

  NOTE: The operator's seat can be adjusted for weights between 50 and 130 kg (110 and 285 lbs).
  
• D — Height adjustment

  After the weight adjustment has been made, the seat can be adjusted to any height. To adjust the height, pull lever (D) up as far as it will go or push it down as far as it will go. The green mark must appear on the indicator scale (B). If the top or bottom limit is reached during height adjustment, set the height slightly lower or higher to ensure a minimum amount of travel up and down (suspension).

• E — Adjust swivel

  IMPORTANT: Use the swivel to the left only for entering and exiting.

  The seat swivel is operated by means of lever (E) as follows:

  Pull up the lever and the seat can swivel freely to the left and right by 15°. To lock, press the lever down and seat snaps into place at the next 7,5° position.

  NOTE: On versions with a multi-function lever on the armrest, swivel the operator's seat to the left only by 7,5°. Avoid collisions with the steering wheel.
  
• F — Adjust tilt of backrest

  Pull lever (F) upwards and hold. Tilt the angle of the backrest to the desired position and let the lever latch back in audibly.

• G — Adjust height of armrests

  At both sides, remove cover (G) and slacken off the hex. nuts. Move the armrests to the desired position and tighten the hex. nuts.

• H — Adjust tilt of armrests

  Knob (H) allows armrest tilt to be adjusted (infinitely variable). To lower the armrest by 30°, press the armrest tilt adjuster (H) into the armrest.

• I — Adjust lumbar support on backrest

  Use knob (I) to adjust the position of the lumbar support.