|
Tractor shifts up and down too frequently.
|
Change the value for engine speed droop → “Set Engine
Droop”
Select an appropriate operating mode → “Set Operating
Modes”
Select start gear in range BC according to the anticipated load
→ "Start gears"
|
|
Tractor shifts too early or too late.
|
Change the value for engine speed droop → “Set Engine
Droop”
Switch off the speed limitation of the engine or change the
setting → “Set Engine Speed Limitation”
Select an appropriate operating mode → “Set Operating
Modes”
|
|
Tractor shifts are rough.
|
Activate SoftShift → “Activate SoftShift when Changing
Gears”
|
|
Irregular ground speed.
|
Select an appropriate operating mode → “Set Operating
Modes”
|
|
Tractor is too slow or too fast.
|
Change setting for maximum travel speed → “Adjust
Maximum Travel Speed”
Remember that speed setting in Full Auto mode always relates
to 100% of the hand throttle or accelerator pedal settings. For this
reason, check the engine speed setting → Adjust Hand Throttle
and/or Accelerator Pedal
|
|
Engine speed is inconstant (when operating the rear PTO).
|
Switch off the speed limitation of the engine or change the
setting → “Set Engine Speed Limitation”
Deactivate SoftShift before operating the rear PTO → “Set
Engine Droop”
Select an appropriate operating mode → “Set Operating
Modes”
|
|
An inappropriate gear is selected at start-up.
|
Within the transmission settings, select the desired start gear
→ "Start gears"
|
|
Difference in speed between forward travel and reverse travel
is too great or too small.
|
Select the desired reverse-forward speed ratio at transmission
settings → “Adjust Ratio between Reverse Speed and Forward
Speed”
|