| Item |
Daily or 10 Hours |
250 Hours |
750 Hours |
| Check Engine Oil Level and Coolant Level |
· |
|
|
| Drain Water Separator |
· |
|
|
| Check Transmission-Hydraulic Oil Level |
· |
|
|
| Lubricate 2WD Front Wheel Bearings, Axle Pivot Pin, Spindles, Cylinder Ends, and Tie Rod Ends ** |
· |
|
|
| Lubricate MFWD Kingpins, Tie Rod Ends, and Axle Pivot ** |
· |
|
|
| Lubricate Hitch Components |
· |
|
|
| Check All Tires |
· |
|
|
| Change Engine Oil and Filter *** |
|
· |
|
| Check Manual Brakes |
|
· |
|
| Service Batteries |
|
· |
|
| Drain Fuel Tank Sump |
|
· |
|
| Inspect Tractor for Loose Bolts |
|
· |
|
| Check Neutral Start System |
|
· |
|
| Check Park Brake System |
|
· |
|
| Clean Cab Air and Recirculation Filters * |
|
· |
|
| Lubricate 2WD Front Axle Pivot Pin, Steering Spindles/Cylinder Ends, and Tie Rod Ends |
|
· |
|
| Lubricate MFWD Kingpins, Tie Rod Ends and Axle Pivot |
|
· |
|
| Check MFWD Axle Housing and Wheel Hub Oil Level |
|
· |
|
| Replace Transmission-Hydraulic Filter * |
|
|
· |
| Replace Fuel Filters * |
|
|
· |
| Check Air Intake System |
|
|
· |
| Check Engine Idle Speeds |
|
|
· |
| Check Coolant and Add Coolant Conditioner |
|
|
· |
| Clean Fuel Tank Vent Filter * |
|
|
· |
| |
| * Interval can vary according to operating conditions |
| ** Operating in extremely wet and muddy conditions |
| *** Change engine oil for the first time after 100 hours maximum of operation, then every 250 hours thereafter (See Engine Break-in Section). If PLUS-50 oil is used with a John Deere filter, oil change interval may be extended by 50 percent to 375 hours |