|
NOTE:
Implements with large hydraulic cylinders can remove substantial volumes of hydraulic oil from the transmission-hydraulic system of the tractor.
Implements which remove large volumes of oil such as Dump Wagons with large single acting cylinders, reference the following:
| Volume of Oil Removed to Raise Load |
Hydraulic Oil Level Required |
| |
|
| 12 Liters (3.2 gal) |
ADD Mark-Engine Off |
| 19 Liters (5.0 gal) |
FULL Mark-Engine Off |
| 21 Liters (5.5 gal) |
ADD Mark-Engine Running |
| 30 Liters (7.9 gal) |
FULL Mark-Engine Running |
|
Cycle all implement cylinders after starting tractor. Check the transmission-hydraulic oil level. (See Check Transmission-Hydraulic Oil Level in the Lubrication Section)
Operation with higher fill levels (if not removed afterward) can result in additional power loss and wasted heat generation the oil cooler has to reject.
Raise function of hitch and extend function of SCVs may be disabled if excessive oil is removed from oil reservoir. Lower the hitch and retract the cylinders to return oil to reservoir.
|