Replacing Fuses and Relays

IMPORTANT: DO NOT install a fuse in location F10. This is for diagnostic readout and calibration of electronic systems used by your John Deere Dealer.

If a fuse is inadvertently installed in this location, be sure key switch is OFF before removing fuse.

Remove magnetic cover to access fuse panel (A).

Remove top and side cover to access relays on upper panel (B) and lower panel (C).

For Open-Station tractors, remove cover to access fuse and relay panel (D).

RW21128A

Fuse and Relay Panel-Cab

RW22103A

Fuse and Relay Panel-Open Station

AG,RF30435,2553 -19-21DEC99-1/1