-
Tighten wheel and axle bolts after 3 hours and after 10 hours of operation, or every 2 hours under severe conditions. (See Wheels, Tires, and Treads Section).
-
Perform daily or 10 hour service. (See Maintenance and Service Intervals Section.)
-
Check engine oil level and coolant level more frequently and watch for any sign of leaks
Engine is ready for normal operation. However, extra care during first 100 hours of operation will result in more satisfactory long-term engine performance and life.
Engine is factory filled with John Deere Break-In Oil. Operate engine at heavy loads with minimal idling during the break-in period. DO NOT exceed 100 hours of operation with break-in oil.
|
IMPORTANT:
Add John Deere Break-in Oil should additional oil be required. Add additional break-in oil only when oil level is BELOW the ADD mark on dipstick. Do NOT fill engine oil level above the FULL mark.
-
Avoid unnecessary engine idling-during the first 100 hours, avoid prolonged periods of engine idling or sustained maximum load operation. If engine will idle longer than 5 minutes, stop engine.
-
Watch coolant temperature closely
-
Check engine air intake system hoses and hose clamps for tightness
|