SCV Lever-Retract Position

Push lever slightly forward of neutral. This slowly retracts cylinder at a variable flow rate as a percent of maximum flow rate (rate set when flow rate was set for corresponding SCV) and proportional to amount of lever travel between neutral and extend detent position. (See Adjusting Selective Control Valve Flow Rate in this section.) Lever returns to neutral and flow stops when released.

Push the lever forward to the first detent notch to retract the remote cylinder at maximum rate. Detent operation mode depends on the SCV detent selected. (See SCV Lever Retract Detent Position in this section).

NOTE: Time setting is ignored in retract position.

AG,RF30435,2076 -19-24AUG00-1/1