|
Perform the following steps to remove tractor from storage:
Remove all coverings in cab
Unseal all openings sealed during storage
Install auxiliary and fan belts
Fill the fuel tank
Check tire inflation pressures-(See Wheels, Tires, and Treads Section)
Install batteries and connect cables
Perform all 10, 250, 500, and 750 Hour services-(See Maintenance and Lubrication Sections)
Check all instruments and indicators by turning key to the ON position
Disconnect fuel shut-off solenoid and crank the engine a few revolutions
|
IMPORTANT:
DO NOT operate the starter for more than 30 seconds. Wait at least two minutes for starter to cool before trying again.
Connect fuel shut-off solenoid and start engine
Operate engine at slow idle for several minutes
IMPORTANT:
If air conditioning compressor is locked up, engine operation with compressor clutch engaged will damage belt or compressor.
Check air conditioning
Check all other system functions
Warm up tractor before putting tractor under load
|