|
Insufficient transport clearance
|
Center link too short
|
Adjust center link
|
|
|
Center link in wrong position
|
Put centerlink in lower hole
|
|
|
Lift links too short
|
Adjust lift links
|
|
|
Implement not level
|
Level implement
|
|
|
Implement not correctly adjusted
|
See implement operator's manual
|
|
|
Upper height limit not correctly set
|
Adjust upper height limit
|
|
|
ILS leveling not functioning correctly or extended above level
|
Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds. Repeat until suspension is in normal operating position.
|
|
Hitch fails to follow lever
|
Malfunction in lever position sensor circuit or hitch position sensor
|
See your John Deere Dealer
|
|
Poor position control
|
Load/depth mix control on wrong position
|
Turn load/depth mix control to the left
|
|
|
System is reset
|
Enable system
|
|
|
Calibration fuse inadvertently moved
|
Be sure key switch is OFF and move fuse to spare position
|
|
|
Malfunction in lever position sensor circuit or hitch position sensor
|
See your John Deere Dealer
|
|
|
ILS leveling not functioning correctly during large draft changes
|
Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds. Repeat until suspension is in normal operating position.
|
|
Hitch drops slowly
|
Hitch rate-of-drop control not correctly set
|
Adjust rate-of-drop knob
|
|
Hitch fails to lift or lifts slowly
|
Excessive load on hitch
|
Reduce load
|
|
|
Center link in wrong position
|
Put centerlink in upper hole
|