Attaching PTO-Driven Implement

causym CAUTION: Entanglement in rotating driveline can cause serious injury or death. STOP THE ENGINE and be sure PTO driveline is stopped before making adjustments, connections, or before cleaning PTO-driven equipment.

Keep PTO shield and driveline shields in place at all times. Make sure rotating shields turn freely.

Wear close fitting clothing. Stop the engine and be sure PTO driveline is stopped before making adjustments, connections, or cleaning PTO-driven equipment.

Lock drawbar in center position and remove clevis assembly.

  PTO Shaft End to
PTO Shaft Hitch Pin Hole (A)
   
540 rpm - 6 Splines * 350 mm (14.0 in.)
1000 rpm - 21 Splines * 400 mm (16.0 in.)
1000 rpm - 20 Splines ** 508 mm (20.9 in.)
 
* 35 mm (1-3/8 in.) Shaft Diameter
** 45 mm (1-3/4 in.) Shaft Diameter

 

Attach implement to drawbar before connecting PTO driveline. If implement will be connected to quick coupler, be sure drawbar will not interfere.

Connect driveline to PTO shaft. Turn shaft slightly by hand, to line up splines. Be sure yoke is in correct position and firmly locked.

Move PTO shield into position for size PTO shaft being used.

TS1644
RW56019A

AG,RX15494,3101 -19-15OCT01-1/1