NOTE: Configure tractor as needed, using ballast guidelines and install implement. Correctly calibrate radar before calibrating tire size.

NOTE: Drive tractor approximately 3.2 km/h (2 mph) in level field, with no draft load and implement raised, to calibrate radar. A change in tire size or loading of tractor can cause angle of radar to change which requires recalibration of radar system.

Mark a straight-line course of 122 m (400 ft).

At starting point, press and hold distance touch switch (A) for 3 seconds. Display will show zero.

Drive tractor at approximately 3.2 km/h (2 mph) to 122 m (400 ft) mark and stop.

NOTE: Do not backup if end point is exceeded. Return to starting point and repeat procedure.

Press percent slip touch switch (B) and distance touch switch (A) simultaneously. Display will show "End" if calibration was successful. If not, display will show "Err" and calibration should be performed again at a slightly faster speed, but less than 11.3 km/h (7 mph).

RW29387,0000423 -19-14OCT04-1/1