|
Start Up Mode
After engine start up, front suspension will move when transmission shift lever is placed into a forward or reverse gear.
Transmission Shifting
Each time the shift lever is moved from NEUTRAL into a forward or reverse gear the suspension will move establishing a mid-point position. Leveling is completed when tractor wheel speed is above 0.5 km/h (0.3 mph).
Operating Characteristics
Unrestricted Suspension Damping:
NOTE:
Left and right suspension cylinders operate independently and will hydraulically adjust through sensors and controllers.
-
Wheel speed is above 0.5 km/h (0.3 mph)
Restricted Suspension Damping:
-
Operator activates hitch raise/lower switch
-
Transmission shift lever placed in PARK
-
Wheel speed less than 0.5 km/h (0.3 mph)
|
-
While correcting for an out of level condition
Brakes:
-
Operator applies both brake pedals
-
Front brakes applied using secondary hand brake lever. (See using Secondary Brakes in this section.)
Rear Hitch:
-
Controllers limit suspension response when hitch is raised or lowered with a load since front weight changes
-
Depressing the clutch and moving transmission shift lever into gear for four seconds and then back to NEUTRAL adjusts suspension toward the mid-point. This can be repeated until tractor levels when attaching and detaching implements.
Parking Tractor:
IMPORTANT:
Prevent possible damage. Do not park tractor with equipment or items under the front end of tractor.
-
Front end can settle when tractor is parked. Keep front end of tractor away from equipment or other items.
|