SCV Lever-Extend Detent Position

Pull lever rearward to "click" detent position and release. Lever will return to neutral position, but flow will continue at rate set on SCV TouchSet panel with SCV flow rate and flow time knobs. (See Adjusting Selective Control Valve Flow Rate and Adjusting Detent Time in this section.)

Flow timing begins when lever is moved into detent. SCV flow time should be adjusted so cylinder will be fully extended when time has elapsed.

Detent can be cancelled by moving SCV lever slightly forward or rearward from neutral after lever has returned to neutral or by holding lever in extend position for more than 0.8 seconds after lever is released from detent.

NOTE: Detent positions ignored at start up until lever is cycled to neutral.

RX15494,000003D -19-06SEP01-1/1