SCV Lever-Retract Detent Position

Push lever forward to "click" detent position and release. Lever will return to neutral position, but flow will continue at rate set on SCV TouchSet panel with SCV flow rate and flow time knobs. (See Adjusting Selective Control Valves Flow Rate and Adjusting Timed Detent in this section.)

Flow timing begins when SCV lever is first moved into detent. SCV flow time should be adjusted so cylinder will be fully retracted when time has elapsed.

Detent can be cancelled by moving SCV lever slightly forward or rearward from neutral after lever has returned to neutral or by holding lever in retract position for more than 0.8 seconds after lever is released from detent.

NOTE: Detent positions ignored at start up until lever is cycled to NEUTRAL.

RX15494,000003F -19-06SEP01-1/1