Using PTO Shield

causym CAUTION: Avoid personal injury. Put the PTO shield in correct position at all times. Do not use shield as a step.

Move PTO shield into correct position for size of PTO shaft being used.

Use shield position (A) for standard or optional 45 mm (1-3/4 in.) 1000 rpm shaft.

Shield should be extended for optional 35 mm (1-3/8 in.) 540 or 1000 rpm shaft. To extend shield, lift up rear portion of shield and tilt front portion of shield down (B). Slide front portion of shield forward and pull up to locked position (C).

RXA0056527
RXA0056528
RXA0056529

RX15494,0000044 -19-06SEP01-1/2

Lift shield to raised position, to provide clearance while connecting implement driveline to the PTO shaft.

Slot (A) must be cut in the PTO shield to connect an implement with an old-style tunnel shield. Cut from the edge of the shield to the small hole.

RXA0056530
RW26283

RX15494,0000044 -19-06SEP01-2/2