Attaching Implement to Quick Coupler

causym CAUTION: To avoid bodily injury or machine damage, put transmission in PARK position and check the full range of hitch for interference, binding, or PTO separation whenever an implement is attached.

Do not stand between tractor and implement.

1. Turn load/depth control (A) fully counterclockwise before attaching or detaching implements.

2. Pull up on coupler latch handles (B).

IMPORTANT: Contacting implement hitch pins with the levers in the locked position may result in damage to the latch mechanism.

3. Lower hitch until quick coupler hooks are lower than implement hitch pins.

4. Back up tractor to implement.

5. Raise hitch enough to engage implement pins in hooks.

causym CAUTION: To avoid bodily injury or machine damage make sure implement is attached correctly. Incorrect attachment can allow implement to be pulled over the tractor wheel and onto the operator station.

6. Push coupler latch handles down to lock implement to quick coupler.

RW55269A
RXA0057299

RX15494,000004D -19-05SEP01-1/2

7. Connect hydraulic hoses and electrical connections.

IMPORTANT: Check for implement interference. Drawbar removal may be necessary.

8. Slowly pull hitch control lever (A) to raise implement. Lower implement to ground and adjust upper height limit control if necessary.

9. Turn load/depth control (B) to desired setting.

IMPORTANT: When quick coupler is not used and if the implement upper mast opening is greater than 70 mm (2.8 in.), or if there is less than 14 mm (0.6 in.) around the upper mast hole, use a combination of shims on both sides of center link ball (C).

RXA0056489
RXA0056494

RX15494,000004D -19-05SEP01-2/2