|
Engine is ready for normal operation.
During the
first 100 HOURS
observe the following:
IMPORTANT:
John Deere Break-in oil must be added if oil level is below the ADD mark on dipstick. DO NOT fill above the crosshatch pattern or the FULL mark.
-
Perform Daily or 10 Hour Service, checking engine oil and coolant levels more frequently
|
-
Tighten wheel and wheel weight bolts
daily during the first week of operation
-
Check for leaks
-
Operate engine at heavy loads without sustained maximum load
-
Avoid idling the engine longer than 5 minutes
-
Closely observe coolant temperature during operation
-
Check air intake system hoses and clamps
|