|
CODE SCo 22
|
Battery voltage out of range
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SCo 27, 28, 29
|
SCV IV or V not working correctly, controller calibration
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCo 40
|
Valve harness connections invalid
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCo 42
|
Front hitch harness connections invalid
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCo 45
|
Implement sensor supply power shorted
|
|
|
|
Hitch may not operate as normally expected
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SCo 47
|
Hitch following sensor voltage out of range
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SC0 58
|
Front hitch raise/lower switch circuit failure
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCo 60
|
SCV levers inoperative, SCV communication link
|
Stop and restart engine
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCo 90
|
Low hydraulic oil level
|
Add hydraulic oil. See Lubrication Section
|
|
CODE SCo 98, 99
|
Remote control system configuration failed
|
Must start tractor with implement connector disconnected to reset control system
|
|
CODE SCo 100
|
Operator not in seat with SCV in detented flow with transmission in NEUTRAL (Warning)
|
If not stationary SCV use, return to seat or move SCV lever to Neutral before leaving cab. See Operator Presence Sensor in Operator Station Section.
|