A-Wheel Slip Percentage
B-Ground Speed

C-PTO Speed
D-Voltage

E-Engine Hours
F-Service Hours

G-Diagnostic Codes
H-Distance Traveled

Display functions are changed using the touch switches on the center of the vehicle monitor.

NOTE: Dashes are displayed for tractors without radar unit.

Tractors equipped with radar, will display true ground speed below 26 km/h. (16 mph) and actual wheel speed above 27 km/h. (16 mph).

The calculated ground speed does not allow for traction slip.

Press % slip switch (A) to display percent of wheel slip.

Press ground speed switch (B) to display true ground speed. Pressing switch a second time will change to a

Press PTO speed switch (C) to display the PTO rpm.

Press volts switch (D) to display the current system voltage in tenths of volts.

NOTE: Tenths of hours digit is half size and decimal point is implied.

Press engine hours switch (E) to display accumulated engine hours.

RX15494,0000113 -19-21MAY04-1/2

Press service hours switch (F) to display operating hours since tractor was last serviced. Display will show current service hours and service book symbol will flash when operating hours since last service exceeds interval set point.

NOTE: The service hour set point can be changed. See your John Deere Dealer.

Default service interval set point is 250 hours. Press switch (F) for 3 seconds to reset to zero after scheduled service.

Press code switch (G) to display code for current active alarm, if any. Press switch to display electronic controller and code number. Record controller and code number for future reference.

Check code displayed with codes listed in Service Codes Section to find possible solution for problem listed beside diagnostic code. If code displayed requires a service technician, identifying the possible problem by using the code number will help arrive at a quicker solution.

NOTE: Alarms can be suppressed, for the duration of the operation, by pressing the code switch for 7 seconds. The alarm will reappear the next time the tractor is started, if the problem still exists.

NOTE: Radar is required for accurate readings to adjust for traction slippage.

Press distance switch (H) to display distance in feet (meters) since tractor was started or distance traveled was reset. Reset to zero by pressing switch for three seconds.

Hold switches (B) and (G) simultaneously to display current engine coolant temperature in degrees Celsius.

Holding switches (C) and (F) simultaneously will display current hydraulic oil temperature in degrees Celsius.

Night-time light intensity for all displays can be adjusted when the light switch is in the "ON" position.

Pressing switches (E) and (F) simultaneously on panel will INCREASE the light intensity. Pressing switches (G) and (H) simultaneously will DECREASE the intensity.

NOTE: Key switch must remain ON for 30 seconds to save new setting.

RX15494,0000113 -19-21MAY04-2/2