MFWD Toe-In Check1. Make sure tires are in the straight forward position by driving tractor in a straight line for at least 50 ft.2. Verify that equal lengths of the steering cylinder are showing on either side of tractor. 3. Measure distance between center line of tires at the hub level in front of axle, using an outside bar of each tire or an inside bar of each tire. Mark the point that is measured. 4. Drive forward until front tires are rotated 180°. 5. Repeat step 3 at rear of tire at same point. 6. Determine the difference between front and rear measurements. The difference may be in either direction (toe-in or toe-out), but should be less than 3 mm (1/8 in.). |
|
RX15494,0000183 -19-22OCT01-1/1 |